Fastener and seam details
Exposed fasteners, concealed clips and standing seams use different connections. Loose attachment needs its cause assessed, not just a surface seal.

Keep water out of the building while preserving the way the metal roof is attached and allowed to move.
A leak in a metal building can involve a panel lap, fastener, curb or penetration. Thermal movement and the actual attachment method matter to the repair. We assess where the water enters and whether the surrounding panels, finish and support can accept a compatible repair.

A repair or restoration needs to fit the panel system.
Exposed fasteners, concealed clips and standing seams use different connections. Loose attachment needs its cause assessed, not just a surface seal.
Curbs and pipe details need compatible flashings and movement allowance. A new rooftop unit can change the water path and service access.
Widespread corrosion, damaged support or wet insulation can require panel or assembly replacement rather than a coating.
The condition of the panels and support sets the limits.
Panel profile, seam and attachment methods make a generic per-foot promise misleading.
Long panels, roof height, end laps, curbs and edge length affect access and installation.
Lift access, loading areas, equipment service and interior protection influence sequencing and cost.
It can address a failed fastener detail when that is the entry point and the panel/support are suitable. It does not repair an unrelated lap, curb or movement problem.
A compatible coating can fit a sound prepared assembly. Corrosion, attachment, seams and wet insulation need assessment before restoration is selected.

Tell us the building location and what the leak or damage is affecting.